New AC Systems for Maurice Homeowners
Maurice sits at the crossroads between Youngsville, Abbeville, and the southern edge of Lafayette, and many of its homes were built during the region’s growth spurts in the 1990s and 2000s. If your home falls into that era, your AC system is approaching or past the 15-year mark where performance starts to decline.
F & R Air Conditioning is based right up the road in Abbeville. We’ve been installing cooling systems throughout Vermilion Parish since 1956, and Maurice homeowners have relied on us for decades.
What Triggers a Replacement
There’s rarely one dramatic moment when you need a new AC. Instead, it’s a gradual slide. Your electric bills inch up over a few summers. The system takes longer to cool the house down in the afternoon. You start hearing sounds from the outdoor unit that weren’t there before. A technician mentions that your capacitor is the third one you’ve replaced in five years.
At some point, continued repairs stop making financial sense. That threshold is different for everyone, but a useful rule of thumb: if the system is over 10 years old and the repair costs more than half of what a new unit would, replacement is the better investment.
The Sizing Step You Can’t Skip
Every AC installation we do in Maurice starts with a Manual J load calculation. This isn’t optional, and it’s not a formality. The calculation determines exactly how much cooling capacity your home needs based on insulation, windows, ceiling height, ductwork, orientation, and other factors.
Why it matters here specifically: Vermilion Parish humidity hovers above 80% for much of the cooling season. Your AC needs to run long enough per cycle to remove that moisture effectively. An oversized system cools the air temperature quickly but shuts off before the evaporator coil has wrung out sufficient humidity. The house hits 72 degrees but feels damp. You crank the thermostat lower, the system cycles on briefly and shuts off again, and comfort never improves.
A correctly sized system runs longer cycles at appropriate capacity, pulling moisture out steadily. The air feels dry and comfortable even during the most humid stretches.
Choosing Your System
Efficiency Levels
The federal minimum is 15 SEER2. Your current system, if it’s from the early 2000s, likely carries a SEER rating around 10-12. Replacing it with a 16 SEER2 unit reduces your cooling energy consumption by roughly 35%. Stepping up to 18 or 20 SEER2 saves more, though equipment costs increase.
We calculate projected savings for each tier based on your home’s actual cooling load. This gives you a concrete number to weigh against the upfront cost difference.
Compressor Selection
The compressor determines how your system manages humidity, which is the most important comfort factor in Maurice’s climate.
Two-stage compressors run at reduced speed most of the time, switching to full capacity only during peak conditions. The longer, lower-speed cycles pull substantially more moisture from the air compared to single-stage equipment. For most Maurice homeowners, this is the recommended option.
Variable-speed compressors provide the finest control, adjusting output continuously to match demand. They deliver the driest, most consistent air and run quietly. They’re the premium choice for homeowners who prioritize comfort.
Brand Options
As a Lennox® Premier Dealer, we carry Lennox’s complete residential lineup. We also install Trane, Amana, Ruud, and Mitsubishi. Your home’s specific needs guide our recommendation.
Everything Included
Our installations cover old system removal, matched indoor/outdoor equipment installation, ductwork inspection and repair, full system commissioning (refrigerant charge, airflow, temperature split), thermostat setup, and a complete walkthrough.
We also recommend setting up a maintenance plan to protect your new system and keep it running at peak efficiency.
Call F & R Air Conditioning at (337) 893-5646 to schedule your free in-home evaluation.